Agilent-technologies J3972A Uživatelský manuál stáhnout pdf (Strana 74)

Installation

Connecting the Probe

Figure 3-5: Connecting the Probe to a 10Base-T/100Base-T Network

Connectin

to Token-Rin

Telemetry Networks

The Token-Ring option must be installed to connect the probe to a Token-Ring

telemetry network.

CAUTION

Connecting the Token-Ring interface to your network when the interface is

configured to the wrong network speed (4Mb/16Mb) can cause

disruption of all

traffic on your network

and it will prevent the probe from properly inserting into

the ring.

You can configure the Token-Ring Speed from the Modify/View Configuration

Values Menu. The probe is configured with a default setting for 16Mbps

networks.

You connect the Token-Ring interface to your network by using the appropriate

cables. The probe has both RJ-45 and DB-9 connectors on the rear panel for

connecting to Token-Ring networks. Figure 3-3 on page 51 shows the back panel

with the Token-Ring option installed.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 188 189

Žádné komentáře

Agilent-technologies J3972A Uživatelský manuál Strana 74