Agilent Technologies N5416A Servisní příručka stáhnout pdf (Strana 179)

Low and Full Speed Tests 7

Notes on USB Electrical Compliance Testing 179

There are several switches/buttons that are used for general control of the

test fixture. These include (see picture below):

• Switch S5 allows you to select either the Droop or Drop test.

• Switch S4 allows you to select either the 100 mA or 500 mA load.

• Press and hold S1 for at least three seconds to turn the test fixture on.

• While pressing and holding S2, press S1 to turn the test fixture off.

You are now ready to begin the Drop or Droop tests. Continue to read this

chapter for specific instructions on performing each of these tests.

USB Power

DS1

S4 Load option

S5 Drop and droop

option

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 235 236

Žádné komentáře

Agilent Technologies N5416A Servisní příručka Strana 179