Agilent Technologies E5500 Series Instalační příručka stáhnout pdf (Strana 31)

Agilent Technologies E5500B Installation Guide

1-23

Welcome to the E5500B Phase Noise Measurement System Series of

Solutions

Step 7. Using the Asset Manager to Configure

your System

The following procedure will configure both the Agilent/HP 70420A Phase

Noise Test Set and PC-Digitizer so they can be used in the E5500A Phase

Noise Measurement System to make measurements.

NOTE If you have ordered a preconfigured phase noise system from Agilent

Technologies, skip this step and proceed to “Step 9. Starting the

Measurement Software” on page 1-36.

1. Make sure your computer and monitor are turned on.

2. Place the E5500 Phase Noise Measurement Software CD-ROM in the

CD-ROM drive.

3. Click the Start button, point to Programs, point to Agilent

Subsystems, point to E5500 Phase Noise, and then click E5500 Asset

Manager.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

Žádné komentáře

Agilent Technologies E5500 Series Instalační příručka Strana 31