Agilent Technologies E8267C PSG Uživatelský manuál

Installation NotePart Number E8251-90275Printed in USA September 2009Supersedes: October 2003 Agilent Technologies PSG Series Signal Generators E8267C

10Figure 3 A17 Baseband Generator Interface BoardW68/A17P421W64/A17P2A173

11Replace the A14 Digital Bus Baseband Generator BoardNOTE If this upgrade kit is being used for the original installation of an A14 Digital Bus Baseb

12Figure 4 A14 Internal Baseband Generator BoardA14W65/A14J800W64/A14J13W90/A14J21

13Install the Digital Bus Cable1. Refer to Figure 5. Connect the loose end of W90 to A17P1 on the A17 Baseband Generator Interface Board.CAUTION Make

14Verify Proper Installation of Option 6021. Turn the signal generator on.2. Check that Option 602 is installed by pressing Utility > Instrument In

NoticeThe information contained in this document is subject to change without notice.Agilent Technologies makes no warranty of any kind with regard to

3Digital Bus Baseband Generator Upgrade KitIntroductionThis upgrade kit adds the Digital Bus Baseband Generator with 64 Msample memory to the E8267C.N

4Installation Kit Parts ListTools Required• TORX T-10 driver• TORX T-15 driver• TORX T-20 driver• 9/16” nut driver• 5mm nut driver• 9/16” socket• 5 mm

5Safety ConsiderationsWARNING Before you disassemble the signal generator, turn the power switch off and unplug the power cord. Failure to unplug the

6Install New Firmware1. Use the installation note, provided in the PSG firmware upgrade kit, E4400-60597, to install new firmware.2. Perform the verif

7Remove the Outer and Inner Signal Generator CoversRemove the Outer CoverRefer to Figure 1.1. Disconnect the power cord.2. Using a T-20 driver, loosen

8Figure 1 Outer Cover Removal

9Figure 2 Inner Top Cover RemovalReplace the A17 Digital Bus Baseband Generator Interface BoardRefer to Figure 3.1. Disconnect the W64 ribbon cable f