Agilent Technologies C-Size VXIbus Systems Uživatelský manuál stáhnout pdf (Strana 92)

MXIbus-4 : Set the VXI-MXI Module’s Logical Address

Set the logical address on your VXI-MXI modules by using the following

steps:

1. Locate the logical address switch, an 8-bit DIP switch at U64. See

Figure 3-11.

2. Determine your system configuration from the following figures:

– 2-Frame System - Command Module (Figure 3-12)

– 3-Frame System - Command Module (Figure 3-13)

– 2-Frame - VXI-MXI (Figure 3-14)

– 3-Frame - VXI-MXI (Figure 3-15)

– 2-Frame - RadiSys EPC-7 (Figure 3-16)

– 3-Frame - RadiSys EPC-7 (Figure 3-17)

– 2-Frame - Agilent V743 (Figure 3-18)

– 3-Frame - Agilent V743 (Figure 3-19)

3. Set the VXI-MXI logical address recommended in the above

figures. Table 3-2 shows switch positions for some of the most

commonly used VXI-MXI logical address.

NOTE Since the VXI-MXI does not have VXIbus resource manager capability, do

not set the logical address for the VXI-MXI to 0.

3-10 Set Up the System for Multiple Mainframes C-Size Configuration Guide

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 177 178

Žádné komentáře

Agilent Technologies C-Size VXIbus Systems Uživatelský manuál Strana 92