Agilent Technologies E6640A EXM Servisní příručka stáhnout pdf (Strana 27)

Quick-Start 1

Getting Started Guide 27

To define RF4 I|O as an input and RF3 I|O as an output, use the following steps.

Define RF4 I|O as an input, using this menu setting or its equivalent command:

Input/Output > More > RF Output & Test Set Config > Half Duplex Config >

RF Input Port > RF4 I|O

Command:

:HDUPlex:PORT:INPut RFIO4

Define RF3 I|O as an output, using this menu setting or its equivalent command:

Input/Output > More > RF Output & Test Set Config > Half Duplex Config > RF

Output Port > RF3 I|O

Command:

[:SENSe]:HDUPlex:PORT:OUTPut RFIO3

NOTE This does not complete the port setup; two more settings are required!

Set up the RF Input using this menu setting or its equivalent command:

Input/Output > RF Input > RF Input Port > RF Input

Command:

:FEED:RF:PORT RFIN

Set up the RF Output using this menu setting or its equivalent command:

Input/Output > More > RF Output & Test Set Config > RF Output Port > RF Output

Command:

:FEED:RF:PORT:OUTP RFO

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 117 118

Žádné komentáře

Agilent Technologies E6640A EXM Servisní příručka Strana 27