Agilent Technologies E1465A Uživatelský manuál stáhnout pdf (Strana 52)

52 Matrix Modules Command Reference Chapter 4

ABORt

The ABORt command stops a scan in progress when the scan is enabled

via the interface and the trigger source is TRIGger:SOURce BUS or

TRIGger:SOURce HOLD.

Subsystem Syntax ABORt

Comments ABORt Actions: The ABORt command terminates the scan and invalidates

the current channel list.

Stopping Scan Enabled Via Interface: When a scan is enabled via an

interface, an interface CLEAR command can be used to stop the scan.

When the scan is enabled via the interface and TRIG:SOUR BUS or HOLD

is set, you can use ABORt to stop the scan.

Restarting a Scan: Use INIT to restart the scan.

Related Commands: ARM, INITiate:CONTinuous,[ROUTe:]SCAN, TRIGger

Example Stopping a Scan with ABORt

This example stops a (continuous) scan in progress.

TRIG:SOUR BUS

! Trigger command will be via

backplane (bus) interface

(*TRG generates trigger)

INIT:CONT ON

! Set continuous scanning

SCAN(@10000:10003)

! Scan channels 00 to 03

INIT

! Start scan, close channel 00

ABOR

! Abort scan in progress

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 104 105

Žádné komentáře

Agilent Technologies E1465A Uživatelský manuál Strana 52