Agilent-technologies Wireless Network Optimization Platform E6474A Uživatelský manuál stáhnout pdf (Strana 56)

56 Agilent E6474A User’s Guide

3 Set Up Your System

How to reset the 1PP2S output on the timing module

The timing module is factory configured to provide a 1PP2S

timing pulse. If, however, the timing pulse has been changed

to 1PPS

, then use the following procedure to change the

timing module output.

This procedure requires the GPSMon software to

communicate with the timing module. Refer to the timing

module manufacturer’s instruction for installing and

configuring the GPSMon software.

1 Connect the timing module to your laptop

2 Provide power to the timing module using a battery or AC

mains

3 From the GPSMon software, select Setup > Ref Pulse

Control. Refer to Figure 29

Figure 29 Open the Ref Pulse dialog box

4 In the Ref Pulse Control dialog box, select 1PP2S option.

Refer to Figure 30 on page 57

1 This may occur when a factory reset command is sent to the module.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 193 194

Žádné komentáře

Agilent-technologies Wireless Network Optimization Platform E6474A Uživatelský manuál Strana 56