Agilent Technologies 54645A Manuál s instrukcemi stáhnout pdf (Strana 26)

Initialization

To make sure the bus and all appropriate interfaces are in a known state,

begin every program with an initialization statement. HP BASIC provides a

CLEAR command which clears the interface buffer:

CLEAR 707 ! initializes the interface of the instrument

When you are using HP-IB, CLEAR also resets the oscilloscope’s parser. The

parser is the program which reads in the instructions which you send it.

After clearing the interface, initialize the instrument to a preset state:

OUTPUT 707;"*RST" ! initializes the instrument to a preset

state.

Information for Initializing the Instrument

The actual commands and syntax for initializing the instrument are discussed in

the common commands section of the online

HP 54645A/D Oscilloscopes

Programmer’s Reference

Refer to your controller manual and programming language reference manual

for information on initializing the interface.

Programming Getting Started

Initialization

2-3

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 110 111

Žádné komentáře

Agilent Technologies 54645A Manuál s instrukcemi Strana 26