Agilent Technologies 83640A Uživatelský manuál stáhnout pdf (Strana 14)

Installation Note 83650-90007 13

Figure 13. RF Deck in the Service Position

46. Connect the new cable W51 to the AT3 attenuator on the RF deck. Position the cable so when the

RF deck is installed it will connect to FL2 without any stress on the cable. Make sure the connection

to AT3 is tight before installing the RF deck.

47. Replace the deck in the synthesizer. Connect W51 to FL2. Be careful that the cable connection to

AT3 remains tight and the cable is not stressed or bent to make the connection. If necessary, remove

the RF deck, loosen the W51 connection to AT3 and reposition the cable as required.

NOTE If the RF deck does not fit easily back into the casting, loosen the RF deck bracket screws

on the side of the synthesizer, slide the RF deck into place, and tighten the screws again.

See Figure 14.

1 2 ... 9 10 11 12 13 14 15 16

Žádné komentáře

Agilent Technologies 83640A Uživatelský manuál Strana 14