Setting up the Hardware for U4154A 2
U4154A Logic Analyzer Installation Guide 37
Step 7 - Connect the Probes to the DUT
As per the testing scenario, use the appropriate probe from
the probing solutions available with Agilent.
You can use:
• Flying- lead probe sets. This is called general purpose
probing. In this probing, connect probe connectors to
individual IC pins or test points.
• Elastomeric probe adapter and 1/4 flex adapter products
available for several types of QFP packages. This is called
QFP package probing. In this probing, connect to all the
pins of a specific QFP package.
• Soft Touch Connectorless Logic Analyzer Probes. This is
called target connector probing or soft- touch
connectorless probing. This probing removes the
connector that is traditionally attached to the target
board and replaces it with an array of probe pads.
• Processor or bus- specific probes. These are called analysis
probes and are available for many processors and buses.
To connect and set up a probe, follow the instructions in the
User’s Guide that accompanies the probe.
Komentáře k této Příručce