Agilent Technologies E6640A EXM Servisní příručka stáhnout pdf (Strana 127)

100

101

Chapter 9 127

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Sequence Setup Commands

3: Analysis Interval

For a description of this parameter, see “3: Analysis Interval” on page 31. The parameter-specific

commands are described below.

SCPI Command

To set the analysis interval as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:ASTep{1:1000}:SETup:

TIME:INTerval <time>

[:SENSe]:LSEQuencer:ACQuire{1:512}:ASTep{1:1000}:SETup:

TIME:INTerval?

To set the analysis interval as an array:

[:SENSe]:LSEQuencer:ACQuire{1:512}:LIST:SETup:TIME:I

NTerval <time>,<time>,<time>,…

[:SENSe]:LSEQuencer:ACQuire{1:512}:LIST:SETup:TIME:

INTerval?

The array form of the command is used to make a different setting for each

analysis interval in the acquisition (the number of array values must match the

number of analysis intervals; otherwise a "settings conflict" error will occur).

SCPI Examples :LSEQ:ACQ2:AST3:SET:TIME:INT 10ms

:LSEQ:ACQ2:AST3:SET:TIME:INT?

:LSEQ:ACQ2:LIST:SET:TIME:INT 500us,1ms,2ms

:LSEQ:ACQ2:LIST:SET:TIME:INT?

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Agilent Technologies E6640A EXM Servisní příručka Strana 127

Komentáře k této Příručce

Související produkty a manuály pro Multimetry Agilent Technologies E6640A EXM