Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Instalační příručka stáhnout pdf (Strana 94)

Chapter 7: Trigger on a 4 Bit Serial Pattern

Run the Analyzer and View the Listing

1 Click the Run button to capture the data.

2 Click the Navigate button.

3 Select the slot with the analyzer you are using, and select

Listing...

4 Under BIT0, right-click and hold to select Binary.

You may only see 0 through -3 lines of data before the trigger, which

would show the serial pattern ‘101’. The analyzer saw the full 4-bit

serial pattern ‘0101’ but did not display enough lines of data before the

trigger to show you this. If you click Run a couple more times, the -4

line of data will show up.

This is the 4-bit serial

pattern.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 145 146

Žádné komentáře

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Instalační příručka Strana 94