Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Instalační příručka stáhnout pdf (Strana 72)

Chapter 4: Installing Oscilloscope Measurement Modules

16533/34A Oscilloscope Module (single or multi-card modules)

16533/34A Oscilloscope Module (single or multi-card

modules)

The Agilent Technologies 16533A/34A oscilloscope module functions as either

a master card or expander card. It is compatible with all versions of software

in your 16700A/B or 16702A/B mainframe. The circuitry in the module

requires an operational accuracy calibration to optimize measurement

accuracy.

A multicard module should contain either all 16533A or 16534A cards.

NOTE: Each of the individual cards of a multicard 16533A or a multicard 16534A

module must first be calibrated as a single card. After reconfiguring into a

multicard module, the channel skew calibration needs to be done.

Step 1

Prepare a single 16533/34A card for calibration

CAUTION: The effects of ELECTROSTATIC DISCHARGE can damage components. Use

grounded wrist straps and mats when you are performing any kind of service

on this module.

1 Power down your 16700A/B or 16702A/B mainframe.

2 Remove all modules and filler panels from the mainframe and set the

PROTECTED/UNPROTECTED switch to UNPROTECTED.

16700A

Power

Busy

16700B or 16702B

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 149 150

Žádné komentáře

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Instalační příručka Strana 72