Agilent Technologies 81134A Uživatelská příručka stáhnout pdf (Strana 55)

Setting Up a Repetitive Burst Signal Setting Up Generic and Advanced Signals

Agilent 81133A/81134A Pulse Generator User’s Guide, September 2008 55

Reconnect the DUT Enable the outputs:

Generated Signal Use the pulse generator’s TRIGGER OUT to trigger a scope.

To set up the trigger output:

1 On the Aux page, in the Trigger Output panel:

– Select the trigger mode Pulse.

One trigger pulse occurs at the start of the repetitive data

pattern.

– Set the Ampl to 1 V.

– Set the Offset to 0 V.

– Set the Divider to 256.

2 Enable the trigger output.

The Aux page looks now as follows:

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 91 92

Žádné komentáře

Agilent Technologies 81134A Uživatelská příručka Strana 55