Agilent Technologies E1356A Servisní příručka stáhnout pdf (Strana 24)

Tree Switch HI Channel

Measurements 1. Make Hardware Connections

• Turn mainframe power OFF

• Connect DMM as shown in Figure 2-4

• Turn mainframe power ON

2. Check for Stuck Channels

• Send *RST to the FET Multiplexer to open all channels

• Trigger the DMM with TRIG SGL and note reading

• Verify the reading is greater than 10 kΩ

3. Check Tree Switch HI Closed Channel Resistance

• Send SCAN:PORT ABUS to enable the tree switches

• Send CLOS (@nn00) to close channel 00 and the A tree switch,

where nn is the card number (typically 01)

• Trigger the DMM with TRIG SGL and note the reading

• Enter the result in Table 2-1 for Tree A HI

• Send OPEN (@nn00) to open channel 00, where nn is the card

number

• Send CLOS (@nn15) to close channel 15 and the B tree switch,

where nn is the card number

• Trigger the DMM with TRIG SGL and note the reading

• Enter the result in Table 2-1 for Tree B HI

• Send *RST to the FET Multiplexer

Agilent E1300B/E1301B

Figure 2-4. Tree HI Resistance Test Connections

2-6 Verification Tests

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Žádné komentáře

Agilent Technologies E1356A Servisní příručka Strana 24