Agilent Technologies N9344C Servisní příručka Strana 169

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 224
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 168
Command Reference 5
Programmer’s Guide 161
Set Custom Scan Channel Quantity For Bottom N Sweep
:CHSCanner:EDIT:BOTTom:CUSTom:CHNumber <value>
:CHSCanner:EDIT:BOTTom:CUSTom:CHNumber?
This command defines custom scan channel quantity for Bottom N
sweep mode.
Example: :CHSCanner:EDIT:BOTTom:CUSTom:CHNumber 200
Key access: Meas > Range Edit > Edit Method Custom, then > Number of Chn
Channel Scanner Display Subsection
Display Switch
:CHSCanner:DISPlay[:STATe] RUN|STOP
:CHSCanner:DISPlay[:STATe]?
This command toggles channel scanner display state between freeze and
refresh. Freeze state stops channel scanning operation, and Refresh state
runs channel scanning operation.
Example: :CHSCanner:DISPlay RUN
Key access: Shift > Disp > Freeze/Refresh
Display Mode
:CHSCanner:DISPlay:MODE TABLe|CHARt
:CHSCanner:DISPlay:MODE?
This command toggles display mode between table mode and time chart
mode. The time chart mode is only available for List sweep mode.
Example: :CHSCanner:DISPlay:MODE CHARt
Key access: Shift > Disp > Disp Mode
Zobrazit stránku 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 223 224

Komentáře k této Příručce

Žádné komentáře