Agilent Technologies Switch/Measure Uživatelská příručka stáhnout pdf (Strana 37)

Getting Started 2

Agilent 34980A Mainframe User’s Guide 29

Wiring and Installing a Terminal Block

If you are planning to use an optional terminal block with your plug- in

modules, follow the next two procedures to connect your external wiring

and install a terminal block.

Wiring a Terminal Block

1 To remove the terminal block cover, insert a screwdriver through the

hole in the cover as shown. Gently push the tab in the direction of the

arrow.

2 While pushing the tab (Step 1), lift the clear plastic cover from the

edge near the D- sub connectors. Slide the cover from under the tab

holders and remove the cover.

WARNING

Before you begin this task, make sure you have disconnected power

from all external field wiring you will be connecting to the terminal

block.

NOTE

For plug-in module pinout diagrams and additional information, refer to

the User's Guide(s) shipped with the module(s).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 183 184

Žádné komentáře

Agilent Technologies Switch/Measure Uživatelská příručka Strana 37