Agilent Technologies 6634A Uživatelský manuál stáhnout pdf (Strana 52)

Connecting the DUT Power Supply Cables

2 If channels 1 through 4 are not available in any

module, cable the 6624A supply to a bank where

both modules have channels 5 and 6 available. Split

the outputs as shown in

Figure 22 on page 50. Notice

that output 2 goes to channel 5 and output 4 goes to

channel 6 on the ASRU Card in the higher numbered

module. It is possible that there will not be enough

ASRU Card channels available to use all of the

power supply outputs. Output 1 goes to channel 5

and output 3 goes to channel 6 on the ASRU Card in

the lower numbered module in the same bank. To

connect all of the outputs, two cables are necessary

since the outputs will go to two modules. Use two

E4000-61602 cables for a 307X system or two

E4000-61606 cables for a 317X system; remember to

connect the banana plug ground on the back of the

power supply and the ground lug connector to the

ASRU Card.

NOTE

A 6624A would not normally be connected to

ports 5 and 6 in a 327X system since these are

reserved for the higher voltage 6634A/B power

supplies.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 81 82

Žádné komentáře

Agilent Technologies 6634A Uživatelský manuál Strana 52