Agilent Technologies 54502A Servisní příručka Strana 24

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 111
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 23
2
Installation
Introduction This section of the manual contains information and instructions necessary for
setting up the HP 1650B/51B Logic Analyzer. This includes inspection
procedures, power requirements, hardware connections and configurations, and
packaging information.
Safety
Considerations
The safety symbols used with Hewlett-Packard instruments are illustrated in the
front of this manual. WARNING and CAUTION symbols and instructions should
be reviewed before operating the instrument. These warnings and cautions must
be followed for your own protection and to avoid damaging the instrument.
Initial
Inspection
Inspect the shipping container for damage. If the shipping container or cushioning
material is damaged, keep it until the contents of the shipment have been checked
for completeness and the instrument has been checked mechanically and
electrically. The contents of the shipment are listed under "Accessories Supplied"
in Section 1. If the contents are incomplete, if there is mechanical damage or
defect, or if the instrument does not operate properly, notify the nearest
Hewlett-Packard office. If the shipping container is damaged, or the cushioning
materials show signs of stress, notify the carrier as well as the Hewlett-Packard
office. Keep the shipping materials for the carriers inspection. The
Hewlett-Packard office will arrange for repair or replacement at HP option
without waiting for claim settlement.
Power
Requirements
The HP 1650B/51B Logic Analyzer requires a power source of either 115 Vac or
230 Vac, -22% to + 10%; single phase, 48 to 66 Hz, 200 Watts maximum power.
Caution BEFORE CONNECTING POWER TO THIS INSTRUMENT, be sure the Line
Voltage Select switch on the rear panel of the instrument is set properly and the
correct fuse is installed.
HP 1650B/1651B Installation
Service Manual 2-1
Zobrazit stránku 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 110 111

Komentáře k této Příručce

Žádné komentáře