Agilent Technologies 54503A Uživatelská příručka stáhnout pdf (Strana 109)

100

101

Chapter 2 109

Making Measurements

Example 9: Adjacent Channel Power Measurement

Stepping Through a Basic ACP Measurement

In this example, we will be using a transmitter with a carrier frequency

of 300 MHz. We will deﬁne the signal that we examine has having a

channel bandwidth of 14.0 kHz and a channel spacing requirement of

20.0 kHz, as shown in Figure 2-53. For this example we will use the

calibrator as the signal source. You would normally provide a signal to

the spectrum analyzer either by connecting a radio directly, or by

coupling a signal from the radio via an antenna.

CAUTION The maximum input to the spectrum analyzer should not exceed +30

dBm (1 W) with greater than or equal to 10 dB attenuation.

Figure 2-52 Adjacent Channel Power Measurement Test Setup

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 715 716

Komentáře k této Příručce

Žádné komentáře

Agilent Technologies 54503A Uživatelská příručka Strana 109

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Agilent Technologies 54503A