Agilent Technologies 1100 Series Uživatelský manuál stáhnout pdf (Strana 23)

Installing your System

Installing the Manual Injector and 1100 series HPLC modules

6 Connect the position-sensor cable to the start cable (see Figure 6).

7 Connect the start cable to an APG-remote connector at the rear of one of the

modules.

8 Connect the CAN-bus cable for the inter-modular communication.

9 Connect the LAN cross-over cable to the detector’s interface board (JetDirect

card).

10 Connect the power cords (AC) to the 1100 modules line input.

Figure 6 Installing the Start Cable (rear view of 1100 system)

Position-sensor (start)

cable

APG remote connector

See Figure 7 on page 24

AC power

LAN to PC

Pump

VW detector

CAN cable

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Žádné komentáře

Agilent Technologies 1100 Series Uživatelský manuál Strana 23