Agilent Technologies 1100 Series Uživatelský manuál stáhnout pdf (Strana 42)

Setting up an Analysis

Before Using the System

NOTE The pump should never be used for priming empty tubings (never let the pump

run dry). Use a syringe to draw enough solvent for completely filling the

tubings to the pump inlet before continuing to prime with the pump.

1 Open the purge valve of your pump (by turning it counterclockwise) and set

flow rate to 3-5 ml/min.

2 Flush all tubes with at least 30 ml of solvent.

3 Set flow to required value of your application and close the purge valve.

Pump for approximately 10 minutes before starting your application.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

Žádné komentáře

Agilent Technologies 1100 Series Uživatelský manuál Strana 42