Agilent Technologies PSG Manuál s instrukcemi Strana 297

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 362
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 296
Command Reference
Power Subsystem ([:SOURce])
Chapter 4 283
:POWer:ATTenuation:AUTO
Supported All with Option 1E1
[:SOURce]:POWer:ATTenuation:AUTO ON|OFF|1|0
[:SOURce]:POWer:ATTenuation:AUTO?
This command sets the state of the attenuator hold function.
ON (1) This choice enables the attenuators to operate normally.
OFF (0) This choice holds the attenuator at its current setting or at a selected
value that will not change during power adjustments.
*RST 1
Key Entry
Atten Hold Off On
Remarks Refer to “:POWer:ATTenuation” on page 282 for setting the attenuator
value when OFF (0) is the choice.
The OFF (0) choice eliminates the power discontinuity normally
associated with the attenuator switching during power adjustments.
During an amplitude sweep operation, signal generators with Option
1E1 protect the step attenuator by automatically switching to
attenuator hold (OFF) mode. The amplitude sweep range is limited to
45 dB. The 45 dB sweep range can be moved by inputting different
power levels.
:POWer:MODE
Supported All
[:SOURce]:POWer:MODE FIXed|LIST
[:SOURce]:POWer:MODE?
This command sets the signal generator’s RF output power operating mode.
*RST FIX
Remarks N/A
Choices ON OFF 1 0
Choices FIXed LIST
Key Entry
Amplitude Ampl
Zobrazit stránku 296
1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 361 362

Komentáře k této Příručce

Žádné komentáře