Agilent Technologies PSG Manuál s instrukcemi stáhnout pdf (Strana 314)

Command Reference

SCPI Command Compatibility

Chapter 4300

OPFA Output start frequency FREQuency:START?

OPFB Output stop frequency FREQuency:STOP?

OPFM1 Output FM sensitivity FM2[:DEViation]?

OPPL Output power level POWer[:LEVel][:IMMediate][:AMPLitude]?

OPSF Output frequency step size FREQuency[:CW]:STEP[:INCRement]?

OPSL Output power slope supported, but no equivalent SCPI command sequence

OPSN Output # points in stepped sweep SWEep:POINts?

OR Output internally measured

power level

not supported

OS Output status bytes see Table 4-8 on page 307 and Table 4-9 on page 308

PL Set power level POWer:ATTenuation:AUTO ON|1

POWer[:LEVel][:IMMediate][:AMPLitude]<val><unit>

PM0 Pulse modulation off PULM:STATe OFF|0

PM1

Pulse modulation on

PULM:SOURce EXTernalPULM:STATe ON|1

PS Power sweep not supported

Remote rotary knob see Table 4-6 on page 304

Recall instrument state *RCL <reg_num>[,<seq_num>]

RE Mask extended status byte see Table 4-7 on page 306

RF0 RF output off OUTPut[:STATe] OFF|0

RF1 RF output on OUTPut[:STATe] ON|1

RM Mask status byte see Table 4-7 on page 306

RP0 RF peaking off command accepted; peaking not required for PSG Family

RP1 RF peaking on command accepted; peaking not required for PSG Family

RS Reset sweep not supported

S1 Sweep, continuous not supported

Table 4-5 8340B/41B Programming Codes and Equivalent SCPI Sequences

Code Description Equivalent SCPI Command Sequence

1 2 ... 309 310 311 312 313 314 315 316 317 318 319 ... 361 362

Žádné komentáře

Agilent Technologies PSG Manuál s instrukcemi Strana 314