Agilent Technologies HP 54601B Uživatelská příručka stáhnout pdf (Strana 30)

To create a mask template using Autostore

An envelop of the passing region can be generated using the Autostore

function. Then the Automask function can read the autostore screen

information and take the maximum and minimum limits of it as the limit lines

of the mask template. This process allows you to create a mask template

from a known good signal, allowing certain tolerance margins.

1 Connect a known good signal to the oscilloscope.

2 Set up the oscilloscope with the settings that are required to test the

signal.

3 Press Display , then toggle the Grid softkey to the off position.

4 Press Autostore .

Make sure that STORE is displayed in the status line. If STORE is not

displayed, press Autostore again.

5 Set the voltage tolerance by moving the waveform up and down with

the vertical position knob, creating a vertical envelop.

6 Set the time tolerance by moving the waveform back and forth with

the horizontal delay knob, creating a horizontal envelop.

You may need to repeat steps 5 and 6 to fine tune the envelop. Cursors can

be used to accurately measure the margins.

7 Press Print/Utility twice.

8 Press the Sequence Admin softkey.

9 Press the Define Automask softkey.

10 Turn the knob closest to the Cursors key to select the mask number.

Operating the Test Automation Module

To create a mask template using Autostore

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 122 123

Žádné komentáře

Agilent Technologies HP 54601B Uživatelská příručka Strana 30