Agilent Technologies 2000 X-Series Servisní příručka Strana 691

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 930
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 690
:WGEN Commands 31
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 691
:WGEN:VOLTage:OFFSet
(see page 790)
Command Syntax
:WGEN:VOLTage:OFFSet <offset>
<offset> ::= offset in volts in NR3 format
The :WGEN:VOLTage:OFFSet command specifies the waveform's offset
voltage or the DC level. Use the :WGEN:VOLTage command to specify the
amplitude.
You can also specify the amplitude and offset indirectly using the
:WGEN:VOLTage:HIGH and :WGEN:VOLTage:LOW commands. For example,
an amplitude of 5 V and an offset of 1 V is the same as a high- level
voltage of 4 V and a low-level voltage of - 1 V.
Query Syntax
:WGEN:VOLTage:OFFSet?
The :WGEN:VOLTage:OFFSet? query returns the currently specified
waveform offset voltage.
Return Format
<offset><NL>
<offset> ::= offset in volts in NR3 format
See Also "Introduction to :WGEN Commands" on page 665
":WGEN:FUNCtion" on page 667
":WGEN:VOLTage" on page 688
":WGEN:VOLTage:HIGH" on page 689
":WGEN:VOLTage:LOW" on page 690
Zobrazit stránku 690
1 2 ... 686 687 688 689 690 691 692 693 694 695 696 ... 929 930

Komentáře k této Příručce

Žádné komentáře