Agilent Technologies Agilent 8166A Manuál s instrukcemi stáhnout pdf (Strana 253)

Timing Behavior GPIB Command Compatibility List

Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition 253

Timing Behavior

Table 15 details the ways in which timing behavior is different.

Table 15 Timing Behavior Changes

Change Affects

Command execution may be different. Both

In all mainframes and modules firmware revisions before 3.x GPIB will

block during command execution, except when executing functions,

such as logging and sweep, that don’t tolerate blocking. This is

identical to the behavior of the 8167/8. A side effect of this is that

*OPC? always returns 1.

In later firmware revisions GPIB only blocks if a command can't be

processed because of a pending command. While a command is

pending *OPC? returns 0 now. This is the behaviour of the 8153.

Both

When continuous triggering and averaging times are greater than 1

second, the read-out values reset after the averaging time is over; there

is no sliding behavior.

8153

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 273 274

Žádné komentáře

Agilent Technologies Agilent 8166A Manuál s instrukcemi Strana 253