Agilent Technologies 8133A Servisní příručka stáhnout pdf (Strana 138)

138 16800 Series Portable Logic Analyzers Service Guide

6 Replacing Assemblies

To remove and replace a pattern generator card

Your product may consist of 1 pattern generator card and 1

measurement card.

1 Perform previous procedures:

• “To prepare the instrument for disassembly" on

page 116.

2 Use a Torx T10 screwdriver to remove the 4 screws

securing the shroud to the frame.

3 Slide the shroud over the cables.

4 Use a gentle back- and-forth motion as you pull to

disconnect the cards from the connector on the module

interface board and then pull the cards out of the frame.

5 Replace the cards.

a Seat the lower card first. The pattern generator card

goes in the lower position.

b Press firmly to ensure the cards are fully seated in the

connector on the module interface board.

c Slide the shroud over the cables.

d Use a Torx T10 screwdriver and 4 screws to secure the

shroud to the frame.

T-10

screws

(4)

Shroud

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 187 188

Žádné komentáře

Agilent Technologies 8133A Servisní příručka Strana 138