Agilent Technologies 85032B/E 50 Specifikace stáhnout pdf (Strana 12)

Test set input/output performance

Parameter Specification Supplemental

Frequency range 3 MHz to 2.2 GHz —

RF input power

Maximum input power — 16 dBm (nominal)

at 0.1 dB compression

Input damage power — 20 dBm (characteristic)

Parameter Specification (dB) Typical (dB)

3 MHz 1.3 GHz 3 MHz 1.3 GHz 2.2 GHz

to 1.3 GHz to 2.2 GHz to 1.3 GHz to 2.2 GHz to 3 GHz

Source match, test port

14 11 18 15 12

Load match, test port unselected

18 18 23 24 20

Load match, test port selected

14 14 18 18 14

Interconnect match, reflection port

12 10 17 15 10

Interconnect match, transmission port

11 8 14 13 11

Insertion loss, reflection port to port-n

7.5 9.5 6 8 12

Insertion loss, transmission port to port-n

7.5 9.5 6 8 12

Tracking, reflection port to port-n

— — 1.5 1.2 1.5

Tracking, transmission port to port-n

— — 1.5 1.2 1.5

Crosstalk, uncalibrated, adjacent ports

90 90 100 95 85

Crosstalk, uncalibrated, non-adjacent ports

90 90 105 100 90

1. Compression is defined for the test set, independent of the network analyzer.

2. This is the match of the test set port that has been selected as the source port. The test set interconnect reflection port must be terminated with a load standard from an

Agilent 85032B/E calibration kit.

3. This is the match of any test port that is unselected (not in the measurement path). Only the source port of the test set is selected when you make a reflection measurement

with one-port calibration. Only the source and load ports of the test set are selected when you make a transmission measurement, or a reflection measurement with two-port

calibration.

4. This is the match of the test set port that has been selected as the load port. A transmission or two-port measurement is required for a test port to be selected as the load port.

The test set interconnect transmission port must be terminated with a load standard from an 85032B/E calibration kit.

5. This is the match of the test set interconnect ports (transmission and reflection ports) with the test set in transmission, or two-port mode. The selected test set test ports must

be terminated with load standards from 85032B/E calibration kits.

6. The reflection and transmission ports of the test set are connected to the corresponding ports of the network analyzer. Port-n is any one of the test ports used to connect to

the device-under-test.

7. This is crosstalk of the test set measured between the test set’s interconnect ports, with shorts on the selected test ports. Crosstalk is computed by normalizing the result of

an isolation measurement to a through measurement between the two ports such that the path losses are taken into account. Isolation is defined as the transmission

signal measured between any two ports of the test system when these two ports are terminated with shorts.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře

Agilent Technologies 85032B/E 50 Specifikace Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Agilent Technologies 85032B/E 50