Agilent Technologies N4962A Uživatelská příručka stáhnout pdf (Strana 55)

Remote GPIB Interface

Serial BERT 12.5 Gb/s User Guide 55

5 Remote GPIB Interface

The N4962A can be controlled and queried with the rear-panel GPIB interface.

The GPIB interface complies with IEEE standard 488.2-1992. To learn more

about the GPIB interface, consult the following books from the IEEE:

• The International Institute of Electrical and Electronic Engineers. IEEE

Standard 488.1-1987, IEEE Standard Digital Interface for Programmable

Instrumentation. New York, NY, 1987.

• .The International Institute of Electrical and Electronic Engineers. IEEE

Standard 488.2-1987, IEEE Stand Codes, Formats, Protocols and

Communication Commands for Use with ANSI/IEEE Std 488.1-1987.

New York, NY, 1987.

A GPIB interface requires that all devices on a common bus have different

addresses; the 5-bit address control switch is located on the back panel next to

the GPIB connector. The factory default address is 25. The address uses a

three digit format. The first digit is always set to “7”, and the last two digits are

programmed by the 5 bit control switch located on the back of the instrument.

The N4980A multi-instrument BERT software is available from Agilent

Technologies for fast GPIB programming of the N4962A.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 87 88

Žádné komentáře

Agilent Technologies N4962A Uživatelská příručka Strana 55