Agilent Technologies InfiniiVision 3000 DSO-X 3054A Servisní příručka Strana 217

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 970
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 216
:CALibrate Commands 9
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 217
:CALibrate:STARt
(see page 860)
Command Syntax
:CALibrate:STARt
The CALibrate:STARt command starts the user calibration procedure.
See Also "Introduction to :CALibrate Commands" on page 211
":CALibrate:PROTected" on page 216
NOTE
Before starting the user calibration procedure, you must set the rear panel CALIBRATION
switch to UNPROTECTED, and you must connect BNC cables from the TRIG OUT connector
to the analog channel inputs. See the User's Guide for details.
Zobrazit stránku 216
1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 969 970

Komentáře k této Příručce

Žádné komentáře