Agilent Technologies B1500A Uživatelská příručka stáhnout pdf (Strana 526)

100

101

9-52 Agilent B1500 User’s Guide, Edition 7

If You Have a Problem

Error Codes

225 Send WSV, WSI, or WNX to get sync sweep data.

If you enable data output of the synchronous sweep source, do not

forget to se

t the synchronous sweep source by the WSV, WSI, or WNX

command. For data output, see the FMT command of Programming

Guide.

226 Set linear sweep for MM4 or MM5.

Only the linear sweep is available for the PWV or PWI

command for

the pulsed sweep measurement (MM4) or the WV or WI command for

the staircase sweep with pulsed bias measurement (MM5).

227 Sweep measurement was aborted.

Sweep measurement was aborted by the automatic ab

ort function or the

power compliance.

228 Pulse period is not set for pulse measurements.

230 Pulse source must be set.

To perform the pulsed spot measurement (MM3), send the PV or PI

mmand to set the pu

lse source.

231 Compliance must be set correctly.

Compliance was not set or an incorrect compliance value was set in

the

PV, PI, PWV, or PWI command. Set the correct compliance value

effective for the pulse output.

238 Too large pulse width (max. 2 s).

The maximum value of the pulse width is 2 s. And the available value

depends on t

he pulse period value. See the PT command of

Programming Guide.

239 Pulse width must be 0.5 ms or more.

Set the pulse width to 0.5 ms or more. See the PT command of

Programming G

uide.

240 Enter QSV to set QSCV sweep source.

The QSV command must be entered to set the sweep source of the

quasi-s

tatic CV measurement.

241 QSR range value must be -9 to -14.

The ra

nge values available for

the QSR command are -9 to -14. Set

one of the available values.

1 2 ... 521 522 523 524 525 526 527 528 529 530 531 ... 627 628

Komentáře k této Příručce

Žádné komentáře

Agilent Technologies B1500A Uživatelská příručka Strana 526

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Agilent Technologies B1500A