Agilent Technologies B1500A Servisní příručka Strana 436

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 598
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 435
4-120 Agilent B1500A/B1505A Programming Guide, Edition 11
Command Reference
LSI
105 : Returns the multi channel pulsed spot measurement settings:
MCPT hold,period,Mdelay,average[[;MCPNT chnum,delay,width]
.... [;MCPNX n,chnum,mode,range,base,peak[,comp]]] ....
<CR/LF^EOI>
106 : Returns the multi channel pulsed sweep measurement settings:
MCPT hold,period,Mdelay,average;MCPWS mode,numOfStep[
[;MCPNT chnum,delay,width]....
[;WNX n,chnum,mode,range,start,stop[,comp[,pcomp]]] ....
[;MCPNX n,chnum,mode,range,base,peak[,comp]] ....
[;MCPWNX n,chnum,mode,range,base,start,stop
[,comp[,pcomp]]]]
.... <CR/LF^EOI>
110 : Returns the parallel measurement mode setting:
PAD mode<CR/LF^EOI>
LSI
The LSI command sets the current search source for the linear search measurement
(MM14). After search stops, the search channel forces the value specified by the
LSM command.
This command clears the LSV, LSSI, and LSSV command settings.
This command setting is cleared by the LSV command.
If Vcomp value is greater than the allowable voltage for the interlock open
condition, the interlock circuit must be shorted.
Syntax LSI chnum,range,start,stop,step[,Vcomp]
Parameters chnum : SMU search source channel number. Integer expression. 1 to 10 or 101
to 1001. See Table 4-1 on page 4-16.
range : Output ranging type. Integer expression. The output range will be set to
the minimum range that covers both start and stop values. For the
limited auto ranging, the instrument never uses the range less than the
specified range. See Table 4-5 on page 4-22.
start, stop : Search start or stop current (in A). Numeric expression. See Table 4-6
on page 4-23, Table 4-8 on page 4-25, or Table 4-11 on page 4-27 for
each measurement resource type. The start and stop must have different
values.
step: Step current (in A). Numeric expression.
Zobrazit stránku 435
1 2 ... 431 432 433 434 435 436 437 438 439 440 441 ... 597 598

Komentáře k této Příručce

Žádné komentáře