Agilent Technologies B1500A Servisní příručka Strana 497

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 598
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 496
Agilent B1500A/B1505A Programming Guide, Edition 11 4-181
Command Reference
SPT?
If no value is set for trailing, the leading value will be used for both
parameters.
Example
Statements
OUTPUT @B1500;"SPT 101,1,0,5E-7,20E-9"
SPT?
This query command returns the pulse timing parameter of the specified SPGU
channel signal source.
Syntax SPT? chnum,src
Parameters chnum : SPGU channel number. Integer expression. 1 to 10 or 101 to 1002. See
Table 4-1.
src : Channel signal source. Integer expression.
1: Pulse signal source 1
2: Pulse signal source 2
Query Response delay,width,leading,trailing<CR/LF^EOI>
delay : returns the pulse delay time (seconds).
width : returns the pulse width (seconds).
leading : returns the pulse leading time (seconds).
trailing : returns the pulse trailing time (seconds).
Example
Statements
OUTPUT @B1500;"SPT? 101,1"
ENTER @B1500;A,B,C,D
SPUPD
The SPUPD command applies the setup of the specified SPGU channels.
The channel output is changed to the following value by this command. And the
waveform or pulse output is started by the SRP command.
base value set by the SPV command, in PG mode
initial value of waveform, in ALWG mode
If a DC bias output channel is specified in the SPUPD command, the channel starts
the DC bias voltage output. And the output is not changed by the SRP command.
Zobrazit stránku 496
1 2 ... 492 493 494 495 496 497 498 499 500 501 502 ... 597 598

Komentáře k této Příručce

Žádné komentáře